1jzgte Posted February 20, 2023 Report Share Posted February 20, 2023 I'm in need of some help. wiring and me do not get on so please explain this to me in plain English I have a Haltech WB1 Wideband which I need to fit to my JZX100 Link G4+ ECU via Canbus. I have been told I need to cut off the plug on the Haltech WB1 ECU side and repin it to this Link connector. This is the WB1 kit, the wire and connector I've been told to chop off is the one with the red and black wires ( the connector with only 2 wires coming out). Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 21, 2023 Report Share Posted February 21, 2023 Connect the Haltech white and blue wires to the JST pin 3 & 2 like below. Red and black to an ignition switched power source. Quote Link to comment Share on other sites More sharing options...
Jparker Posted March 29, 2023 Report Share Posted March 29, 2023 Hi 1jzgte and Adamw, Where can I purchase the 5pin JST connector suitable for the CAN port on my plug and play ECU? Thanks in advance! Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 29, 2023 Report Share Posted March 29, 2023 It is a JST XA series connector XAP-05V-1, last time I looked they were pretty scarce with a long lead time like a lot of the electronics industry but I haven't looked recently. Try the usual suppliers, RS, Element 14, Mouser. Jparker 1 Quote Link to comment Share on other sites More sharing options...
Jparker Posted April 2, 2023 Report Share Posted April 2, 2023 Thanks Adam, I'll see how I go! Shame to buy the pre-moulded lead when I would prefer it be just JST to tails. Cheers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.