Duncanator Posted March 28, 2023 Report Share Posted March 28, 2023 I am having some trouble finding info on how to wire in fuel level for my Strada dash since I am deleting the stock cluster. How can I tap into the stock wiring and then how do I properly set up a fuel level gauge on the dash? Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 29, 2023 Report Share Posted March 29, 2023 The doc here should give you enough info, but if you dont understand it then post back and I will try to simplify it. Page 4 for fuel level. https://www.aim-sportline.com/download/faqs/eng/hardware/sensors/mx_series/FAQ_Sensors_MXSStrada_Alarm_LEDs_100_eng.pdf Quote Link to comment Share on other sites More sharing options...
Duncanator Posted March 29, 2023 Author Report Share Posted March 29, 2023 19 hours ago, Adamw said: The doc here should give you enough info, but if you dont understand it then post back and I will try to simplify it. Page 4 for fuel level. https://www.aim-sportline.com/download/faqs/eng/hardware/sensors/mx_series/FAQ_Sensors_MXSStrada_Alarm_LEDs_100_eng.pdf Hey! Thank you for replying. I am actually very new to wiring. I do know, I am able to use the wires that go to the stock cluster. I am just trying to figure out where I need to connect the pump sender wire to either the expansion loom on the ecu or straight to the strada dash. And if you wouldn’t mind dumbing it down a little haha. Thank you! Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 30, 2023 Report Share Posted March 30, 2023 The fuel level sensor wire will need to be connected to one of the analog inputs on the dash, you will also need a pull-up resistor of about 200ohms connected between the signal wire and the aim +Vreference pin. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.