troyj Posted April 8, 2023 Report Share Posted April 8, 2023 I have just wired my 2006 n70 hilux speedo using the link ecu so i can calibrate the speedo as it was 10kph out with it running straight to the cluster. now iv wired the input from gearbox speed sensor to di8 and output to aux injector 8 to cluster it works but soon as it see movement it sits on 20kph then works from there when stops it gose to 20kph then pause then drops to 0kph on speedo when it doses the key on sweep it works fine . Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 8, 2023 Report Share Posted April 8, 2023 Does it read correctly at speed? There is a min frequency on the G4+ aux outputs which it sounds like might be around your 20kmh frequency. On most speedos it is low enough that you dont see it. Quote Link to comment Share on other sites More sharing options...
troyj Posted April 8, 2023 Author Report Share Posted April 8, 2023 Yes at 100kph iv got it right but when it come back down as you slow down it will pause at around 20kph then drop to 0kph when stopped but soon as you move again say your doing 2kph it jump to 20km then go from there Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 9, 2023 Report Share Posted April 9, 2023 Yeah you are not going to be able to get around that. 10Hz is the lowest frequency the aux outputs can produce, it sounds like that is about 20Kmh on your speedo, so you are never going to get any speed between 0 & 20kmh. Quote Link to comment Share on other sites More sharing options...
troyj Posted April 10, 2023 Author Report Share Posted April 10, 2023 Ok allgood Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.