eimer Posted May 5, 2023 Report Share Posted May 5, 2023 Force GDI was running and has been for awhile now was driving and it shut down. when I plug in and check data I have no rpm. When I do a trigger scope is see/have both triggers looking as they should but outside of that nothing in that department. everything else fuel/sensors/etc all seem to be just fine. When ignition cycles fuel pump primes. Also checked setup settings for triggers and seems as it should also Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 5, 2023 Report Share Posted May 5, 2023 Can you attach a copy of the tune, the scope file and a short log of it cranking. Quote Link to comment Share on other sites More sharing options...
eimer Posted May 6, 2023 Author Report Share Posted May 6, 2023 here is the info you were asking for link start log 05052023.llgTrigger Scope Log 2023-05-5 5;58;31 pm.llglink gdi engine file.pclr Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 6, 2023 Report Share Posted May 6, 2023 There is no signal from the crank sensor at all, it is just sitting at 0.5V the whole time in the scope, the camshaft shows the correct signal. Quote Link to comment Share on other sites More sharing options...
eimer Posted May 6, 2023 Author Report Share Posted May 6, 2023 ok thanks when I was looking at it I thought the dips in it were the teeth cause it 60-2. I will investigate the crank signal Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.