Cant read Vehicle Speed on Link AIM MXG 1.2 Strada

[fabiangt79]

Hi,

I have setup the can input from link fury ecu to dash, everything runs fine, Rpm, sensor readings..

After i setup GP Speed Input to DI2, i test the speed on runtime the speed is active and picking up signal from the speed sensor.

I used the race studio 3 software to setup the dash and selected the speed to dash, transmit and upload to dash.

The dash speed doesnt move like the link ecu runtime.

Anyone can advise and help on this?

Attached datalog 

PC Datalog - 2023-05-7 8;57;46 pm.llgx

[Adamw]

Only the 4 wheel speeds are sent to the dash in the default MXS CAN stream.  Assign one of your wheel speed inputs as DI 2 in >chassis and body>speed sources

[fabiangt79]

remove the GP input speed for DI2 and assign to left wheel speed speed sources, right?

[fabiangt79]

works well.

Can i also check for the wideband lambda Aim display shows 1.00 unit, can i change to AFR 14.7

i tried searching true the settings it cant change the unit

[Adamw]

Yes the default lambda/afr channel units dont work correctly, this is due to our older ecu's broadcasting AFR and our newer ones broadcasting Lamabda so the setup is a compromise so both work.  It is quite easy to set up a math channel to generate AFR.  

In RS3, go to >math channel>add channel>linear corrector.  Name the new channel AFR or similar, choose ECU WBO2 LAM1 as the channel, set multiplier to 14.7.  Click save and then you will have a new AFR channel that you can add to your display pages.