dcr42t Posted August 29, 2014 Report Share Posted August 29, 2014 Hi, have been trying to log the ecu by pressing record under the logging tab, and then open the mixture map, so I can adjust my fuel table. I get the "Unable to draw mixture map" Log file error: Fuel table parameter missing, wideband parameter missing etc When I right click on the mixture map table and select properties, I understand I am meant to pick the correct sources for the rpm, wideband, fuel load, and target load. My mixture map settings don't have the fuel table section at the top, as in the mixture map help file. Can someone point me in the right direction in selecting the correct sources. My wideband is connected to an volt 5, so I selected that for the wideband source. But Im not sure exactly which source im meant to choose for the fuel load, rpm, and target load. Thanks Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted August 29, 2014 Report Share Posted August 29, 2014 Hi, post your PCL file up and I will set it up for you. Regards Dave. Quote Link to comment Share on other sites More sharing options...
Gsab Posted August 31, 2014 Report Share Posted August 31, 2014 Dave, can you also post the pcl here ? I have pretty much the same problem and do not know how to set these all up. Thanks, B. Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted September 1, 2014 Report Share Posted September 1, 2014 Hi, I could post up a generic setup, but doesn't mean it will suit your application. PM me your PCL file if you don't want it on the site. I am sick at present so I will get to it as soon as I am up to it. Regards Dave. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.