Sparkystav Posted June 27, 2015 Report Share Posted June 27, 2015 I recently updated my link G4 to the latest firmware after realising I was a few years behind. However once I did it my inlet and water temps were in fault until I disabled the fault alarm. I'm using the standard Lexus sensor for coolant and a 2 wire aftermarket one for inlet temp. Both are 2 wire one to analog input and one to ground but the ecu was bringing up 'analog input at 5v' for both and refusing to allow the car to start till I disabled these fault alarms. They now work correctly and show the correct temps on the link software, however on my dash2 using the serial ecu interface they both still show -49degC; I.e the fault position. Can you help recitify this, I've looked through all the pages and setups I can find with no help or solution. Thanks Quote Link to comment Share on other sites More sharing options...
Simon Posted June 29, 2015 Report Share Posted June 29, 2015 In theory if the PC link software is showing correct then the display is using the same information and should follow. If you change the error value to another figure does the dash follow? Quote Link to comment Share on other sites More sharing options...
Sparkystav Posted July 22, 2015 Author Report Share Posted July 22, 2015 Finally got chance to have a look, I've now set the fault value to 95degc and the dash2 still displays -49 so it's not just like its reading something different. But it's worked previously, all I did was update the link. Has the setting for temp 1 and 2 moved over the updates? Quote Link to comment Share on other sites More sharing options...
Simon Posted July 23, 2015 Report Share Posted July 23, 2015 Are the other functions coming through.I would check the Baud rate and data stream settings as the baud rate can change with a firmware upgrade. Quote Link to comment Share on other sites More sharing options...
Sparkystav Posted July 23, 2015 Author Report Share Posted July 23, 2015 Oddly yes they are, I thought baud rate etc too, but my boost and voltage readings are still coming through and correct, just the two temps (inlet and coolant) Quote Link to comment Share on other sites More sharing options...
Simon Posted July 24, 2015 Report Share Posted July 24, 2015 If you would like to post your map I can have a look for any settings that might have been missed. Quote Link to comment Share on other sites More sharing options...
Sparkystav Posted July 24, 2015 Author Report Share Posted July 24, 2015 Here you go, hope you can help scoff 20150621 updated software.pcl Quote Link to comment Share on other sites More sharing options...
Sparkystav Posted July 24, 2015 Author Report Share Posted July 24, 2015 Scrap that. I've fixed it. With the older firmware the dash2 read an temp 17 (an temp 1) and 18 (an temp 2) for Iat and ect. With the newer firmware it's the same as the vipec as temp 1 (Iat) and temp 8 (ect). Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.