motionper Posted May 19, 2014 Report Share Posted May 19, 2014 where can i find some more info on the logging functions, are there any math channels i would like to record clutch and driveshaft speed Quote Link to comment Share on other sites More sharing options...
Simon Posted May 20, 2014 Report Share Posted May 20, 2014 ECU Logging Parameters up to and including ECU firmware version 4.9.8   The following parameters are able to be logged in ECU logging mode:    AN Volt 1 to 11 Inj timing   Anti-Lag Cyclic Idle Knock Count Global   Anti-Lag Ign Cut Knock Level Global   AN Temp 1 to 4 Knock Threshold   BAP Launch Limit   Batt Voltage MAP   CL Stepper Limit MAP Limit   Digital Frequency 1 to 6 Mass per Cyl (x100)   Dwell Time Max Ignition   E-Throttle Limit MGP   ECT Overrun Fuel Cut   ECU Temperature RPM Limit   Engine Speed Speed (DI 1 to 6)   Fault Codes Speed Limit   Gear TP (Main)   GP RPM Limit 1 and 2 Trig 1 Err Counter   IAT Under Voltage   Ign Angle Voltage Limit   Inj Actual PW Wake-Up Status   Inj Duty Cycle (Sec) VVT Cam Position  ECU Logging Parameters from ECU firmware version 4.9.9 onwards    The following parameters are able to be logged in ECU logging mode:    AFR Target Inj timing   AL Active Fuel Table (Status) Knock Count Global   Altitude Knock Level Global   AN Volt 1 to 11 Knock Threshold   Anti-Lag Cyclic Idle (Status) Launch Limit (Status)   Anti-Lag Ign Cut (Status) MAP   AN Temp 3 and 4 MAP Limit (Status)   BAP Max Ignition (Status)   Batt Voltage MGP   Boost Target Overrun Fuel Cut (Status)   CL Stepper Limit (Status) Percentage FCut   Cruise Switch Mode (Status) Percentage ICut   Differential Fuel Pressure RPM Limit (Status)   Digital Input 1 to 12 (Status) Speed (DI 1 to 6)   Dwell Time Speed Limit (Status)   E-Throttle Limit (Status) Timer 1   ECT Timer 2   ECU Temperature TP (Main)   Engine Speed Trig 1 Err Counter   Fault Codes Under Voltage (Status)   Gear Voltage Limit (Status)   GP RPM Limit 1 and 2 (Status) VVT Cam Position   IAT Wake-Up Status (Status)   Ign Angle WGate DC   Inj Actual PW Wideband 1   Inj Duty Cycle    Inj Duty Cycle (Sec)  Quote Link to comment Share on other sites More sharing options...
Simon Posted May 20, 2014 Report Share Posted May 20, 2014 I should note that with PC logging you can select the channels you want where as the internal logging is fixed to those above. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.