Subiguy1 Posted July 7, 2023 Report Share Posted July 7, 2023 According to the manual i need to install a resistor between the ecu and the gauge itself, i am confused where i should be putting this resistor on which wires. Can H/Can L In-between them? do i have to use the Terminating Resistor jumper in anyway? Can Gauge Online Manual.pdf (linkecu.com) Quote Link to comment Share on other sites More sharing options...
DerekAE86 Posted July 7, 2023 Report Share Posted July 7, 2023 You don't need to. The gauge has one built in via the jumper. By default it's enabled - you only remove the jumper if you have more than 1 guage as only the last device on the CAN line needs it. Assuming you have a LINK ECU it also has the resistor built in. Quote Link to comment Share on other sites More sharing options...
Subiguy1 Posted July 7, 2023 Author Report Share Posted July 7, 2023 Okay thank you @DerekAE86 I didn't full understand the manual, good to know im good to go with you gauge! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.