Boost table 3 as a compensation table

[Crispin]

It seems that boost table 3 is designed to be a compensation table. But to do so I would like to input values as a % of the main boost table.

For instance, I would like to use both a 0-5 volt boost adjust knob AND boost adjusted by TPS.

Ideally I would set this up by using table 1 as  boost duty cycle vs voltage (assuming WOT/100%TPS). Then to reduce boost at lower throttle I would use table 3 with 0-100% throttle on the y-axis. Start with -100% boost DC at 0% throttle and gradually change this to 0 at 100% throttle.

Any good ideas how to set this up with the current tables?

 

 

[Top Tune NZ]

why do you want to do this ?