Yorick3097 Posted September 20, 2023 Report Share Posted September 20, 2023 hi, I'm new here in the forum and wanted to describe my problem. I bought the Lambda to CAN module from Ecumaster and can't get a signal in. I also soldered a 120R 1/4W to the other end of the CAN cable as described in the instructions. CAN High and CAN Low are connected correctly. The strange thing is that the lambda display also lies to me when I use it via an analog signal. Has anyone already had experience? Subaru V3 map.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 20, 2023 Report Share Posted September 20, 2023 Your map is attached with the user stream and ID fixed. have assumed the lambda device is wired to CAN1, if not then you will have to turn off user stream 1 on CAN one and enable it on CAN2. Subaru V3 map CAN fixed.pclx Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.