Jump to content

link injector drive


michael francis

Recommended Posts

do you have the installation manual? as this is covered in it. you need to check the impedance of the injectors with a multimeter set to the ohms range. just unplug the injector and touch the probes to the pins if the reading is above 6ohms(4 a g3 link at least not sure about others) you dont need ballast resistors. if it is lower than 6 you will require the correct resistors from link

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...