troyj Posted October 7, 2023 Report Share Posted October 7, 2023 i installed a link can lambda to the gx4 v11 plug in that in a v12 2014 wrx sti i setup as the instructions when i went to find devices i came up straight away. Then after it came up to unplug power to can lambda i done that and plugged back in it now wont find the can lambda iv checked pins and power ect now when on the sensor is heating im getting 3v and about 2v on the can wires? also on the dash im getting si drive fault center diff fault flashing donnys wrx.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 8, 2023 Report Share Posted October 8, 2023 Go to >Analog inputs>Lambda 1 and set the control to Link CAN. . For the dash errors, can you try changing the CAN2 mode to the WRX07-11 key start mode, then power cycle ignition after storing. Quote Link to comment Share on other sites More sharing options...
troyj Posted October 8, 2023 Author Report Share Posted October 8, 2023 Ok sweet ill try that tonight Quote Link to comment Share on other sites More sharing options...
troyj Posted October 9, 2023 Author Report Share Posted October 9, 2023 I sorted it i done what you said but didn't fix the can lambda but i worked out i must of configured it on 500 bit rate and now reconfigure back to 1 now all working Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.