My5t3ryM4nN Posted October 18, 2023 Report Share Posted October 18, 2023 Hi, So I'm adding a AIM MXS Strada into my e36 that will have a G4X PnP in it, since these two will be speaking to each other over CAN. Is it possible to wire an analog boost map switch to the AIM MXS directly and that input be able to trigger different maps on the G4X? Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 18, 2023 Report Share Posted October 18, 2023 Yes you can send pretty much anything that is in the dash back to the ecu, including sensors etc if you run out of ecu inputs. Quote Link to comment Share on other sites More sharing options...
My5t3ryM4nN Posted October 19, 2023 Author Report Share Posted October 19, 2023 Adam, Thanks for the quick reply! I have a haltech 12 position rotary switch I was originally going to put on my XS Harness but would it be possible to run that directly to the MXS? (I'm not too familiar with the DI support on the MXS) Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 19, 2023 Report Share Posted October 19, 2023 Yes. Quote Link to comment Share on other sites More sharing options...
My5t3ryM4nN Posted October 20, 2023 Author Report Share Posted October 20, 2023 Just to be 100% sure, I would use the following three pins on the MXS? +Vreference (5V Power) Analog input (Signal) Analog GND (Signal Ground) Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 20, 2023 Report Share Posted October 20, 2023 correct Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.