ae82ted Posted October 30, 2023 Report Share Posted October 30, 2023 Hi, I've some problems with connecting the Link RET to MonsoonX and the Ethrottle. Connected TPS Main/Sub to AN Volt 3&4 Connected APS Main/Sub to AN Volt 1&2 Connected M+ and M- or RET to throttle body motor Connected Signal 1&2 of RET to AUX3/4 of Monsoon. Connected Enable* wire to AUX6 of Monsoon and set as Ethrottle Relay The APS calibration can be done properly. However, the TPS calibration cant go through, and prompted no movement of TPS main detection. I'm not sure whether that's the problem with the RET Enable wire.. All wirings look ok for my understanding. The Calibration setup as per below pic. Opps All good now. Double-checked the wiring the M- misplaced at the RET unit. Thanks for attention. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.