shazad hanif Posted August 7, 2007 Report Share Posted August 7, 2007 I have wrxlink G3 pnp with xs conector and the inovate lc-1 with xd 16 display ,how shall i wire xs conector(with brown,green ,yellow wires on it) to wideband 02 and narraw band 02 to get to get readng on the pclink and what configrations i have to do in an volt2 options please explain in detail thank you shaz Quote Link to comment Share on other sites More sharing options...
ashesman Posted August 7, 2007 Report Share Posted August 7, 2007 OK, you will wire the Analog Out 1 of the LC1 to the XS connectors An Volt 1 wire (closest to edge of circuit board in XS connector). You will then set An Volt 1 as Wideband #1. In the calibration information, enter the same numbers that you have setup in the Innovate programming software... Quote Link to comment Share on other sites More sharing options...
shazad hanif Posted August 8, 2007 Author Report Share Posted August 8, 2007 n wat to do for the CLL for idle Quote Link to comment Share on other sites More sharing options...
ashesman Posted August 8, 2007 Report Share Posted August 8, 2007 You will use that wideband sensor to do CLL on An Volt 1. Reverse the calibration from 0 to 5 volts to 5 to 0 volts and CLL will work fine. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.