Steven Oakley Posted October 2, 2012 Report Share Posted October 2, 2012 Hi iv just gone a got a G4 Storm for my CA18Det Im running a stroker kit LC1 wide band Lamba F.P.R 1000cc High Inpen injectors Im going to be using the bosh sensor aswell I dont want to run the map sensor so im going to use the in built map sensor.  Is there anything else that im going to need and is the a base map i can load to start me off? Quote Link to comment Share on other sites More sharing options...
Simon Posted October 2, 2012 Report Share Posted October 2, 2012 You will likely need an igniter to drive the coils, If you have the factory one this will be fine. The ECU will have a good starting point loaded but you will have to configure inputs outputs and triggering to suit the CA18. Quote Link to comment Share on other sites More sharing options...
Steven Oakley Posted October 2, 2012 Author Report Share Posted October 2, 2012 Thanks how would i go about running the on board map, Instead of my M.A.F sensor? Yes i do still have the igniter Quote Link to comment Share on other sites More sharing options...
Simon Posted October 3, 2012 Report Share Posted October 3, 2012 You just need to run a vacuume line from the intake manifold (engine side of butterfly) to the port on the ECU Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.