bradley peterson Posted October 11, 2014 Report Share Posted October 11, 2014 I can't seem to get the gear cut to work. I would also like it to function as launch control. Can anyone give me some advice? Quote Link to comment Share on other sites More sharing options...
Simon Posted October 13, 2014 Report Share Posted October 13, 2014 Hi Bradley we will need a bit more information on how you have the gear cut configure and what you are using to activate it. Posting the PCL file will be a good start. Quote Link to comment Share on other sites More sharing options...
bradley peterson Posted October 13, 2014 Author Report Share Posted October 13, 2014 I have a clutch switch wired to digital input 2. It is powers through a 5 amp fuse and a toggle switch. When I activat the toggle it sends 12 volts to the clutch switch. When the clutch is pressed the switch closes and sends power to dI2.  As soon as the clutch starts to engage te switch opens. I have tried di2 as go switch, clutch switch, and gear cut. when using clear cut it shows me activat and off when I press the clutch. It jyet don't dont work.  dI2 set up  pull up resistor off,  high, active edge falling Quote Link to comment Share on other sites More sharing options...
bradley peterson Posted October 13, 2014 Author Report Share Posted October 13, 2014 I'm not sure what pcl file is Or how to post it. Quote Link to comment Share on other sites More sharing options...
Simon Posted October 14, 2014 Report Share Posted October 14, 2014 PCL file is the tune in the ECU. If you connect to the ECU and then go to file and save as the saved file is the one we want. Quote Link to comment Share on other sites More sharing options...
bradley peterson Posted October 19, 2014 Author Report Share Posted October 19, 2014 Hear is my pcl file Quote Link to comment Share on other sites More sharing options...
Simon Posted October 21, 2014 Report Share Posted October 21, 2014 You will need to change your on level to high and active edge to rising. This will get the configuration correct to act as gear cut. Quote Link to comment Share on other sites More sharing options...
bradley peterson Posted October 31, 2014 Author Report Share Posted October 31, 2014 That got it working once. If I tern the car off and back on it will not activate. I tried saving it several times and the config is now correct.  but it will not work until i change the  di2 to gp or clutch switch then back to gear cut it will work  great until the ignition is off.  I shouldn't have to set it up every time I want to use it. any suggestions? Quote Link to comment Share on other sites More sharing options...
bradley peterson Posted November 1, 2014 Author Report Share Posted November 1, 2014 Is that not the same as f4 Quote Link to comment Share on other sites More sharing options...
Simon Posted November 2, 2014 Report Share Posted November 2, 2014 Yes that is the same as F4 I have tried your file in an Atom on the bench and it seems happy. The biggest difference is the firmware I am testing on the latest 4.10.2 I would suggest you should look at doing a upgrade as what you currently are running will have a number of bugs that have been resolved in the latest. Quote Link to comment Share on other sites More sharing options...
bradley peterson Posted November 13, 2014 Author Report Share Posted November 13, 2014 updated the firmware and that fixed it. Thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.