dual wideband on v6

[John Tosh]

Is it possible for me to configure  my inputs to accept 2 widebands on a v6 engine so that both banks can be monitored or adjusted 

[Dave Kriedeman]

Hi Josh,

Yes this is possible.

Just setup to AN VOLT INPUTS as widebands/ LAMBDA 1 and LAMBDA 2 and setup you AFR/LAMBDA TARGET table.

When you data log to keep it simple and clear set up 1 group up as Lambda 1/AFR and Target Lambda /AFR

Set up the second as Lambda 2/AFR and Target Lambda /AFR.

You need to have your injectors wired upas sequential obviously.

You then go to the fuel tab and go to Individual Fuel trim.

I have attached 2 examples of how this can be done.

The CAL 4 file is just a created CAL don't use those values.

Regards

Dave.