Tor_m Posted March 12, 2015 Report Share Posted March 12, 2015 Hi, sorry my bad english, im from Norway. I got a Aeromotive fuel cell sith a singel wire universal fuel level sender 0-90ohm. I wired it up to the An temp 4 an set it up as Gp Temp, and Cal table 1. Setup cal table 1 input unit Ohms and calibratet it right. Got it working, BUT when I fire up the car it goes -30, and in runtime values it stand Input at 5V. Why does it do that? Quote Link to comment Share on other sites More sharing options...
Simon Posted March 13, 2015 Report Share Posted March 13, 2015 Do the temp sensor readings for engine and air temp stay correct? Suspect the signal is being pulled higher than 5V this could due to a 12 volt supply being connected to the 5V out. Quote Link to comment Share on other sites More sharing options...
Tor_m Posted March 13, 2015 Author Report Share Posted March 13, 2015 Yeah those are fine. Quote Link to comment Share on other sites More sharing options...
Simon Posted March 17, 2015 Report Share Posted March 17, 2015 If you could Email the map to [email protected] we will try on the bench to see if it is the same. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.