Nburns Posted May 31, 2016 Report Share Posted May 31, 2016 Wiring in a link fury to a 2jz, requires single wire knock sensor. What wire needs to connected black or wire?Thanks Quote Link to comment Share on other sites More sharing options...
Scott Posted May 31, 2016 Report Share Posted May 31, 2016 Hi,If you are using the factory knock sensor, and it only has one pin, wire this to the pin 'Knock 1' on the B connector of the Fury. If you are fitting a knock sensor to the engine then I would recommend fitting a 2 pin wideband type knock sensor. This is because most OEM knock sensors only output a narrowband frequency and the band needs to match the resonant knock frequency of the particular engine.Scott Quote Link to comment Share on other sites More sharing options...
Nburns Posted May 31, 2016 Author Report Share Posted May 31, 2016 Thanks for the quick reply, the small booked supplied with my ecu has both knock out puts marked blue when the cable itself has white and black. Thanks for clearing that up. Cheers Nick Quote Link to comment Share on other sites More sharing options...
Davidv Posted June 1, 2016 Report Share Posted June 1, 2016 (edited) JZ motors have two knock sensors, one at each end of the block?Are you sure that you dont have two seperate shielded wires, one for each single wire knock sensor on the engine. If so, wire up one each to knock 1 and knock 2. Edited June 1, 2016 by Davidv Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.