Adamc Posted September 28, 2018 Report Share Posted September 28, 2018 I've been trying to add boost target psi, ethanol content, coolant pressure, and throttle body differential pressure to my can stream, and i cannot quite figure out where im going wrong. if one of you could take a peak and tell me if i'm missing something glaringly obvious that would be super helpful. i believe i have added them to the can outputs, but im not quite 100% positive. Any help with the dash design software would also be greatly appreciated. here are my dash design and tune files. thanks! 9_22_18 580hp 27psi_updated can profile.pclr rev5.0.aemcd7 Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 28, 2018 Report Share Posted September 28, 2018 You have done it right at the ECU end. I will set up the dash end to match when I get more spare time later today. Quote Link to comment Share on other sites More sharing options...
Adamc Posted September 28, 2018 Author Report Share Posted September 28, 2018 adam you are awesome!!!!! thank you so much i eagerly await your help! thank you again Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 29, 2018 Report Share Posted September 29, 2018 Try attached. I have created both KPa and Psi channels for your pressure inputs. rev5.1.aemcd7 Quote Link to comment Share on other sites More sharing options...
Adamc Posted September 29, 2018 Author Report Share Posted September 29, 2018 It worked perfectly! Thank you so much Adam! I thibk after seeing this I have learned how to add additional parameters to the can stream. I have a few other things id like to add now! I appreciate the help! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.