xAv Posted April 29, 2019 Report Share Posted April 29, 2019 I have a plug'in G4+ ecu feet on. As show on the picture attached, I've found a sensor on the clutch pedal, ready for but not connected. As anyone have an idea where is going the signal ? Any special pin on the ECU wiring ? Thanks in advance. Xav Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 29, 2019 Report Share Posted April 29, 2019 Sorry, just edited my post, I must be half asleep. The clutch switch should be DI4, pin C25. Quote Link to comment Share on other sites More sharing options...
xAv Posted April 29, 2019 Author Report Share Posted April 29, 2019 Thanks a lot Adamw, but in DI4 I already have the waterspray, and it works well... Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 29, 2019 Report Share Posted April 29, 2019 So your "Spec C" car most likely has the water spray connected to the pin that the clutch switch is connected to. The clutch switch is normally DI4. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.