AEWON Posted June 24, 2019 Report Share Posted June 24, 2019 Hi there, please see attached wiring schematic, I’m in the middle of wiring up a canbus loom from a G4+ plugin S13 ecu which i believe has an inbuilt resistor for canbus, then next I have a Link can lambda and then last in the chain a Motec C125, am I correct in that I should use Can 2 output on the G4+ as i’ll be connecting the dash to the motec “ecu” connector which is also labeled as Can 2 and also a spliced in resistor? Cheers Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 24, 2019 Report Share Posted June 24, 2019 You can use either CAN 1 or 2 at the Link end. You can also use either CAN 1 or 2 at the Motec end but their normal convention is to use CAN 2 for the ECU. Quote Link to comment Share on other sites More sharing options...
AEWON Posted June 24, 2019 Author Report Share Posted June 24, 2019 Thanks Adam, think i’ll stick with CAN 2 to keep my OCD at bay Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.