Monsterbishi Posted November 14, 2019 Report Share Posted November 14, 2019 Picked up a G4+ CAN Lambda unit this week, I see in the instructions that it says to install the sensor at least one metre downstream to avoid overheating the sensor. I was planning on using the factory O2 sensor location but it is situated circa 500mm downstream of the engine (NA 302 windsor) - should I weld the supplied boss further downstream or just use the factory location? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 14, 2019 Report Share Posted November 14, 2019 That will be fine on a NA engine. I have some cars with them in the primaries with no drama. Quote Link to comment Share on other sites More sharing options...
Monsterbishi Posted November 14, 2019 Author Report Share Posted November 14, 2019 Cheers Adam Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.