Fadi@Tensai

i will reverse the polarity (i assume the ground and power) keeping the signal wire untouched , first thing in the morning and try again. i hope the problem gets resolved

thanks for the reply but i can read RPM as you can see in the log! can you please have a look at the VVT inlet and exhaust tooth count . link base file says its 2 . isn't it 3 teeth? link base file for the G4+ list the trigger offset as 145 degrees, but in the g4X base map its 0! what is the correct setting?

Dear All, i have wired in a Link Extreme G4x with a Link Razor PDM to start a Toyota 3SGE Beams VVTI (grey top) engine. the trigger setup data was exported from Link Plugin Base Map for Altezza. i did all input and out put correctly and tested the injectors and ignition out put successfully . the problem is during cranking the car don't start because injectors and coils are not firing. OEM Coils, Injector Dynamics 1050x injectors. any help is highly appreciated. trigger scope, log and tune attached. 3SGE PC Datalog - 2023-12-14 7;16;59 pm.llgxSE3G Beams Grey Triggers.llgxXtreme Altezza Datsun 1050x Base 2.pclx