seized

Just curious, now that the G4+ has a faster processor, can the digital input frequency limit be raised? For Turbo RPM input without a converter box.

Previously Paul M wrote: Anyone recommend an egt amplifier? AEM has a nice quad EGT amp. 5 volt out as well as RS232 output.Â

Ugh Link please dont waste time on this, focus on firmware features!!!

This would be awesome, I have the same thing with multiple EGT channels.

You can use the raw signal, it gets connected to a digital input. The 0-5v converter is not needed.

In my opinion, the screen resolution will make way more impact than processor speed. A 7' tablet is probably only 1024x700. Tops. At that low resolution things are difficult.

Yay, CL Boost!

Checked the easy things like the hose being split open or kinked? Any sign of fluids in the hose?

Do you have details about the sensor? If its a VR (variable reluctance) sensor, you would need a converter. If its a hall sensor it shouldnt. If you have the wiring diagram, the easiest way to tell between the two would be that the hall sensor would have a power supply wire going to it. VR sensors are passive and have no power supply. If its an ABS sensor, its probably VR.

You need a speed sensor on a driven wheel. Then you can enter the gear ratios yourself, or let it learn them.

No, the wire you have labelled 'ECU-' would go to whatever pin you want to be the output. So one of the Aux output pins. The wire labelled '12V Constant' is correct. Note that you want a fuse between the relay and the battery.

Its only in the Vipec software. Steve I sent you a message.

I think the cable you need is called 'CAN05'. Its mentioned in this thread. http://www.linkecu.com/forum/forums/G4Forum/377110836 I am ordering one from www.apexspeedtech.com right now, but there might be a closer distributor for you.

This would be a great feature!

Has anyone setup a 4D map with it yet?