Dynodom

Hello Dave I understood this part already. But I want to be able to flick switch ( DI 9 ) to disable the AUX14 output at any given time

Apologies, I noticed that I put my question in the wrong section, G4 instead of G4+ I need to configure a AUX output to be dependent on a DI input condition The purpose in question is to arm/disarm the supercharger clutch Thank you for your support

Hi I have set up an AUX14 output which will switch a relay above 1500 rpm or >throttle. Now, I want to be able to turn this function off and on by the use of a toggle switch which is hooked up to DI9. I have tried to find the solution but I am stuck. Please advise. Thank you

Thank you

Hello Car: Nissan 350Z, MY 2007 Link Plugin ECU 2x Link O2 Sensors CAN As soon as I connect the CAN bus lines from the O2 controller, the car CAN bus goes to limp mode (engine fan full speed). CAN H and L are correct. Power supply to O2 CAN controllers are 12.5 V, new cables for power feed installed. CAN wires from O2 controllers are tightly twisted. I gather that this ECU has only one CAN bus (2). When I attempt to detect new CAN device, none is found. I am totally lost here, having spent many hours to get it to work following closely the instructions Thank you for your help in advance Dom