Kimple Fi Posted June 3, 2019 Report Share Posted June 3, 2019 Hi everyone. I am replacing the original injectors (340cc) larger injectors(1600cc) .. What do I need to change the settings?. Quote Link to comment Share on other sites More sharing options...
Simon Posted June 4, 2019 Report Share Posted June 4, 2019 Will depend a bit on fuel equation mode. For traditional divide your master fuel by 4 and adjust dead time and short pulse width tables to suit new injectors. Then tune from there. In modeled mode you will need to change the injector flow rate and the dead times and short pulse width tables. Then tune. Quote Link to comment Share on other sites More sharing options...
Kimple Fi Posted June 4, 2019 Author Report Share Posted June 4, 2019 Ok , thank you ! Quote Link to comment Share on other sites More sharing options...
Mario Schneiderbanger Posted June 4, 2019 Report Share Posted June 4, 2019 9 hours ago, Simon said: Will depend a bit on fuel equation mode. For traditional divide your master fuel by 4 and adjust dead time and short pulse width tables to suit new injectors. Then tune from there. In modeled mode you will need to change the injector flow rate and the dead times and short pulse width tables. Then tune. What if you started with stock injectors in traditional mode and have a solid calibration and now you’re switching to ID injectors and want to use Modeled fuel? Anything else besides the obvious: -flow rate -dead times -short pulse Kimple Fi 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.