Atomic_stone Posted October 29, 2019 Report Posted October 29, 2019 Hey guys, i have just setup Individual coils on my RB30. I used the expansion loom and plugged it into connector 2 on the ecu where all of the ignition outputs are and I’ve swapped the ignition main over to direct spark. When i I go to test the coils, only coil number 1 is firing, no other coils seem to operate. When I look at the ignition auxiliary outputs, the ignition drives are all greyed out and turned off, and I am unable to change anything. Many help would be much appreciated. Quote
Brad Burnett Posted October 29, 2019 Report Posted October 29, 2019 Did you do a store when you changed over to direct spark? Im not 100% on this with link, but i know some ecu manufactures will require the power to be cycled after a large change such as wasted/distributed to direct spark. Try a store(control+s or f4) then try power cycling the ecu. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.