Jayden1jz Posted November 13, 2019 Report Share Posted November 13, 2019 Why do my injector or ignition drivers not turn on all other out outs that are setup turn on but not those.. they test fine Quote Link to comment Share on other sites More sharing options...
Ducie54 Posted November 13, 2019 Report Share Posted November 13, 2019 If this is a new install did you unlock the ECU. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 13, 2019 Report Share Posted November 13, 2019 If you are looking at the "Auxiliary" runtimes then this is normal, they only show "on" when assigned to auxiliary output functions. The drives that are used for inj/Ign will just show "off" all the time. Quote Link to comment Share on other sites More sharing options...
Jayden1jz Posted November 13, 2019 Author Report Share Posted November 13, 2019 All sorted goT it to run. Has a good miss though and will only start with a master setting of 35 or higher... Quote Link to comment Share on other sites More sharing options...
cj Posted November 13, 2019 Report Share Posted November 13, 2019 have you calibrated trigger1 with a timing light? 35ms master value is really high on pretty much any injectors unless the fuel table numbers are all single digits. Quote Link to comment Share on other sites More sharing options...
Jayden1jz Posted November 13, 2019 Author Report Share Posted November 13, 2019 I know once running I can drop down to 18-20 but I have put cranking enrichment up to 150% but won’t start while at 18-20ms will check with a timing light tomorrow Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.