Gabet Posted April 5, 2020 Report Share Posted April 5, 2020 I’m looking to run the aem cd-7 digital dash with the canbus plug in harness. But I already have the link g4 wideband plugged in to the canbus. Anyone have any way how I can run both of them? And info would be great! Thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 5, 2020 Report Share Posted April 5, 2020 The whole idea of CAN bus is you can have multiple devices all talking in different directions via the same two wires. The only limitation is they must all talk at the same bit rate. Your dash and CAN lambda both have configurable bitrates and so that is fine. Standard CAN bus wiring should look like this: Quote Link to comment Share on other sites More sharing options...
Gabet Posted April 5, 2020 Author Report Share Posted April 5, 2020 So I would have to wire in the can-h and can-l to the dash and the link wideband and they both will work. From what you sent me. I have to leave 20mm to 30 mm between there each one is connected. Quote Link to comment Share on other sites More sharing options...
Gabet Posted April 5, 2020 Author Report Share Posted April 5, 2020 Dumb question. What happens if the wires for the CAN-H and CAN-L are not twisted? Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted April 5, 2020 Report Share Posted April 5, 2020 1 hour ago, Gabet said: Dumb question. What happens if the wires for the CAN-H and CAN-L are not twisted? Not a lot, under most conditions it will work perfectly, but the noise immunity will be reduced Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.