cappo_nz Posted May 5, 2020 Report Share Posted May 5, 2020 Hi all I have recently received an AtomX and I'm trying to set up an arduino based CAN device to send messages to the ECU. The issue I'm having at the moment is an error when I try to find devices in the CAN Setup menu, I get an error for "CAN Bridge Failed - Check ECU Firmware". I updated my firmware last night to the latest available. Any ideas on why this is happening? I have checked that there is a 120ohm resistor at the end of my CAN lines, and my output messages appear to be configured correctly. Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 5, 2020 Report Share Posted May 5, 2020 The find devices tool is only used for reprogramming link can lambda devices to a different cyl number or baud rate etc. it is not used for 3rd party devices. Quote Link to comment Share on other sites More sharing options...
cappo_nz Posted May 5, 2020 Author Report Share Posted May 5, 2020 Thanks Adam, I was getting hung up on that and not actually having a look to see if any data was coming through, but all 4 of my analog inputs and all 8 digital inputs seem to be working perfectly. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.