bradsm87 Posted June 27, 2020 Report Share Posted June 27, 2020 It would be great to see low range transfer case switch recognition and 2 separate sets of RPM/Speed gear detection gears. Without the gear detection knowing transfer case status, it could never be able to tell the difference between L3's 4.078:1 ratio compared to H1's 4.084:1 for example. I think a good way would be a new input/runtime for transfer case status as "low range" and "high range" that can be used anywhere on the ECU as needed plus the ability to have two sets of stored RPM/Speed gear detection ratios that are switched by the transfer case status switch. An easy way to start with might be to simply allow the addition of a Y axis on the gear ratio table so someone can add a switch status as a Y axis and set up the ratios for each. Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 27, 2020 Report Share Posted June 27, 2020 Yeah I think this is a decent idea, it could potentially also cover the drift guys that swap diff ratios regularly. bradsm87 1 Quote Link to comment Share on other sites More sharing options...
bradsm87 Posted June 28, 2020 Author Report Share Posted June 28, 2020 9 hours ago, Adamw said: Yeah I think this is a decent idea, it could potentially also cover the drift guys that swap diff ratios regularly. That'd be great. Even just allowing a Y axis config so we can assign a switch status to it would be great. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.