Tom's r32 gtr Posted July 20, 2020 Report Share Posted July 20, 2020 I’m currently making a harness for the can-lambda sensor, (for r32 Gtr using g4+ pnp) similar to the one on nzefi website. Im using the Can 1 Jx header on the ecu board. The wiring diagram provided is confusing me... is this correct and where does the “to ecu” wire go? Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 20, 2020 Report Share Posted July 20, 2020 Here is the diagrams from the current quick start guide. Preferred option at top with The lambda powered from its own relay connected directly to the battery. The alternative wiring below with the extra capacitor is if you are not using its own relay but instead connecting to some other power supply in the car such as in this example the ECU relay: As for the CAN wiring, it should be like below, also with a 120ohm resistor across the CANH/L wires near the CAN lambda connector: Quote Link to comment Share on other sites More sharing options...
Tom's r32 gtr Posted July 21, 2020 Author Report Share Posted July 21, 2020 Thank you, I’ll report back with whatever happens when I plug it in Quote Link to comment Share on other sites More sharing options...
Goon Posted October 15, 2020 Report Share Posted October 15, 2020 Still confused about can h and l ... any help would be appreciated so close to having my skyline done On 7/20/2020 at 8:02 PM, Tom's r32 gtr said: Thank you, I’ll report back with whatever happens when I plug it in Any good news ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 15, 2020 Report Share Posted October 15, 2020 18 hours ago, Goon said: Still confused about can h and l ... any help would be appreciated so close to having my skyline done What are you stuck on? Do you have the CANPCB and CANF? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.