Guest |987| Posted December 8, 2011 Report Share Posted December 8, 2011 Hi, i think there is a something wrong on setting the injector outputs. If you load the "V88 EJ20 Quad AVCS" basemap( its a 4 cylinder) and switch the 5,6,7 or 8 Injector output one time from off to Injection they became locked. Its not possible to switch back. With the v88 basemap its the same . If you set under config 6 cylinders you not be able to switch the injector outputs 7 and 8 off or to something else they also locked. The ignition settings works as expected. I test this with 4.8.8.1129 and 4.8.8.1112 without a ecu connected. Quote Link to comment Share on other sites More sharing options...
Gerhard Posted December 8, 2011 Report Share Posted December 8, 2011 viewtopic.php?f=3&t=873 Quote Link to comment Share on other sites More sharing options...
Guest |987| Posted December 8, 2011 Report Share Posted December 8, 2011 Thanks for the answer. So i had to power on my ecu on the desk to make my basemap? Whats the reason for this behavior? I like it to have my basemap and setup near ready before wire in the ecu. Quote Link to comment Share on other sites More sharing options...
Guest |59| Posted December 9, 2011 Report Share Posted December 9, 2011 It is very easy to power up a V44 or V88 on the bench. Quote Link to comment Share on other sites More sharing options...
Simon Posted December 11, 2011 Report Share Posted December 11, 2011 Some functions must be set with the ECU powered up. This is due to the way the menory locations are assigned. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.