ozzy Posted September 9, 2020 Report Share Posted September 9, 2020 So i have link g4+ wrx v3-v4 plugin for my 98wrx. I have a complete swap intake tb et. I cant seem to get my v7 idle control valve to work. Old model has 2 wires going to ecu. One to close one to open and one power 3 wires in total. New one has one ground one power and one signal. I have tried open loop changed the wiring(and cancelled close wire(b137-2) . Tried aux 1 through 5. . Any advice is welcome Thanks Quote Link to comment Share on other sites More sharing options...
Simon Posted September 9, 2020 Report Share Posted September 9, 2020 The set up will be vary similar to the 2 wire control but with only one channels needed. Just pick an Aux and then assign as ISC Solenoid. Check the frequency settings etc and make sure the second drive is now turned off. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.