Electredge Posted November 21, 2020 Report Share Posted November 21, 2020 I have all the trims zero'd out, using only 1 target table Boost Target Table has boost set to 200kpa at 75-100% Throttle and 0kpa at 0% Throttle somehow between gear shifts it changed boost target from 200-244... but if you look closely it appears to have offset the entire boost target by adding 44kpa to everything... after letting off the 3rd gear part of the pull you can see it doesn't fall back to 0kpa target as it should. let me know if anyone has any suggestions... the ecu log is too large to post but I will attach the map on the next post Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 21, 2020 Report Share Posted November 21, 2020 Can you also share the log with Google drive, onedrive, dropbox or similar. Quote Link to comment Share on other sites More sharing options...
Electredge Posted November 21, 2020 Author Report Share Posted November 21, 2020 48 minutes ago, Adamw said: Can you also share the log with Google drive, onedrive, dropbox or similar. I emailed it to [email protected] .... but I'll see if I can share it here with google https://drive.google.com/file/d/194H5w6X8wb-ELYSiFhk7VV1gyJKqrv7k/view?usp=sharing, https://drive.google.com/file/d/1LaaBkm4y5bxsz784kCOAVVl89IPSeiPE/view?usp=sharing Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 21, 2020 Report Share Posted November 21, 2020 Can you update to the latest firmware and try to reproduce. Even if you set your target lower for testing it should be a valid test. I found a similar bug noted in our system where if you passed through a 0 target in your boost target table when there was a negative trim applied it would add trim to the target after that point. During that gear change you do move through a zero target cell so I think this is related to the same bug that has already been fixed. Electredge 1 Quote Link to comment Share on other sites More sharing options...
Electredge Posted November 22, 2020 Author Report Share Posted November 22, 2020 20 hours ago, Adamw said: Can you update to the latest firmware and try to reproduce. Even if you set your target lower for testing it should be a valid test. I found a similar bug noted in our system where if you passed through a 0 target in your boost target table when there was a negative trim applied it would add trim to the target after that point. During that gear change you do move through a zero target cell so I think this is related to the same bug that has already been fixed. seems to have fixed it, I also got rid of the 0 target as well just in case but no longer having the issue. Thanks Adam Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.