Mr_Flibble Posted November 24, 2020 Report Share Posted November 24, 2020 So after setting the triggers et al I started the engine and it runs very rough and dies after a few seconds. Following the instructions I check the logs for the trigger events and it has only gone up by 1 each time I try to start it. Looking through the logs but I can't seem to find a cause, so where should I be looking ? Any help appreciated. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 24, 2020 Report Share Posted November 24, 2020 Have you followed the first time start-up instructions in the manual and adjusted master fuel etc? Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted November 24, 2020 Author Report Share Posted November 24, 2020 Theoretically, yes. But I will run though it again. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 25, 2020 Report Share Posted November 25, 2020 If that doesnt get you any further then please do a PC log of a start up attempt and attach that and your tune file here. https://www.youtube.com/watch?v=_P1LRANeO4A Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted November 25, 2020 Author Report Share Posted November 25, 2020 error my bad Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted November 25, 2020 Author Report Share Posted November 25, 2020 Ok, it started but is quite lumpy, I'll sort the timing out next. sol2.pclr Log 2020-11-25 6;25;24 pm.llg Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 25, 2020 Report Share Posted November 25, 2020 Obviously timing is critical so that is the first step. What size injectors are they? Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted November 25, 2020 Author Report Share Posted November 25, 2020 They are currently stock which means about 240cc and why I have turned down the supercharger. Would you recommend about a 400 cc injector ? It does feel like it's not running on all cylinders and the smell of unburnt fuel is quite high. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 25, 2020 Report Share Posted November 25, 2020 Just the injector PW looked more than I would expect, but with injectors that small it may not be too far off. The will unlikely be big enough to support any boost at all, but they are not going to stop you from getting it to run/idle. You need to check the timing and find why some cylinders arent working then by the sounds. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.