Evo 9 PnP box w/Expansion Harness - One additional sensor?

[R/TErnie]

I have the PnP box for the Evo 9 and I purchased it with the expansion connector expecting that i would have additional Digital Inputs, Analog inputs, and AnTemp inputs.

The expansion harness only provides for an Analog input (which I used for oil pressure)

I've run out of Digital inputs by using an E85 content sensor and a turbo speed sensor. I'd like to run the clutch switch for Gear Cut, but I'm fresh out of Digital Inputs.

(I'm out of analog inputs and an temp inputs too)

Do you have any plans to make the expansion harness utilize the extra wires? Evo 9 ECU pins are available through Dynotech (Jamie) here in the states so I can pin un-used ECU pin locations for additional inputs...unfortunately I don't know that the vi-pec has anything on the otherside of the board...and it's documented that way.

Thank you for your help. It's great to have a way to communicate with the people writing the code... really closes the loop pun intended.

-Eric Urness

[Simon]

To allow the extra inputs will require changing over to a higher spec topboard. We are investigating this as an option currently.