Ado Posted June 5, 2021 Report Share Posted June 5, 2021 Hi all I have the fury ecu wired to my K20 in my sevenesque kit car. I and trying to get the vtc solenoid to work- I have taken the aux out 1 orange/balck wire to the solenoid and the taken a +12v from a ignition switched relay. I am getting +12v from the + feed - all good, and with the solenoid off Aux out 1 is +12V and when you switch the Aux 1 test on it drops to +10.1 volts There is no option to switch it to low side Am i right in thinking Aux out 1 should drop to gnd when i switch the test on ? I have fitted a new genuine vtc solenoid and have tested this with a 12v supply but it wont work when i put it on test within the software Any help is appreciated Adrian. Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 5, 2021 Report Share Posted June 5, 2021 Yes, aux 1 should go to near 0V when in Test (ON). Are you measuring the 10.1V with the solenoid unplugged or is that with the solenoid connected? Quote Link to comment Share on other sites More sharing options...
Ado Posted June 6, 2021 Author Report Share Posted June 6, 2021 9 hours ago, Adamw said: Yes, aux 1 should go to near 0V when in Test (ON). Are you measuring the 10.1V with the solenoid unplugged or is that with the solenoid connected? unplugged - Is their any settings that can cause this ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 6, 2021 Report Share Posted June 6, 2021 25 minutes ago, Ado said: Is their any settings that can cause this ? Not that I can think off. Can you do a similar test on some of the other auxes. Aux 1-4 are all part of the same chipset so try one from this set and one from Aux 5-8. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.