JOEL Posted June 13, 2021 Report Share Posted June 13, 2021 Hi everyone, I have a Link G4X in an rb25 s2 and I'm trying to set up the IAT sensor, its a GM sensor and there's no option for that one. From what I've read, I need to set up a cal table, I've tried doing what I can and the temperature now shows at 0c instead of 150c Anyone with a similar sensor able to help? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 13, 2021 Report Share Posted June 13, 2021 It’s in the software as Delphi AC IAT or similar Quote Link to comment Share on other sites More sharing options...
JOEL Posted June 15, 2021 Author Report Share Posted June 15, 2021 Hi Adam, Thanks for your response, When I select the "Delphi AC IAT" the temperature shows -40c, do you know why would it show -40c? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 15, 2021 Report Share Posted June 15, 2021 That would probably suggest there is no connection. If the voltage on the pin is outside of the voltage range you set for error high/low then it will assume the sensor has failed and assig whatever value you have set for the fault value, that is likely -40 in your case. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.