AL4SPN Posted August 16, 2021 Report Share Posted August 16, 2021 Hi, I have a Haltech WB1 connected and setup as per the documentation, CAN ID950 but it doesnt seem to work and am recieving CAN errors, (will get screenshot) I also have a AIM Strada dash this work fine until i loop through the WB1 and then this stops displying data as well Has anyone else had this issues or can shead some light on it? Cheers Chris Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 16, 2021 Report Share Posted August 16, 2021 The fact it is taking the whole bus down (dash loses data) would suggest either the wiring is wrong (CAN H/L swapped or similar), or the device is programmed for the wrong bit rate. I dont think the Haltech bit rate is adjustable so it sounds more like a wiring issue. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.