quick tune target different to my AFR target table

[Stu]

hi guys - I have a cell in my AFR target table set to 0.98 at idle but if I use quick tune the target says 1.28 so it tries to lean it out real bad. What am I doing wrong? Cheers

[Adamw]

It should come directly from the AFR/Lambda target parameter as far as I know.  Can you give me a pic similar to below, a copy of your tune, and a log from the same time the pic was taken.

[Stu]

sorry mate, I just wasted your time - i just realised i had rubbish data in my open loop AFR target overlay table. i reset that now its all good.