RKGarage Posted September 11, 2021 Report Share Posted September 11, 2021 Hey guys, I have bought 2 Rotary Trim Dial's. Using one for Boost Control Table Interpolation which I think I have set up correctly. I want to use the 2nd one to adjust Launch control rpm limit. Having some difficulty on figuring this out as it doesn't seem as straight forward as the Boost Control. Any tips and tricks ? Cheers Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 11, 2021 Report Share Posted September 11, 2021 This example I have a 10 position switch, I used a cal table so that the switch voltage gets converted into a "position 0-9". Then put this parameter on one axis of your launch table. Quote Link to comment Share on other sites More sharing options...
RKGarage Posted September 11, 2021 Author Report Share Posted September 11, 2021 Ahhhh, yup my bad. Exact same as boost I just didn't go about it correct. Thankyou for the quick advice! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.