josey Posted September 17, 2021 Report Share Posted September 17, 2021 Hi guys, idea is to reduce wheel spin on launch by limiting engine speed, over ground speed input. Idea is to set GP RPM limit to limit rpm and to get better 60ft times. please advise is this setup correctly (startup lockout and activation delay) or if you have better idea im listening. This rev limiter should kick right in after releasing clutch. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 17, 2021 Report Share Posted September 17, 2021 Launch control mode 3 gives you the same thing - a 3D launch table, generally use wheel speed and gear. Then you can keep your GP limits for safeties. Quote Link to comment Share on other sites More sharing options...
josey Posted September 17, 2021 Author Report Share Posted September 17, 2021 yes i was looking into that, and something like this should give me same results? and on ign retard table i can set ign timing / retarding tables overlap ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 17, 2021 Report Share Posted September 17, 2021 Yes sometimes you can use retard at the same time as a method to reduce the amount of cut required. In turbo applications though retard can sometimes cause a boost increase so you need to test to see what works. Quote Link to comment Share on other sites More sharing options...
josey Posted September 18, 2021 Author Report Share Posted September 18, 2021 Adam, thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.