Papajon2.0 Posted September 22, 2021 Report Share Posted September 22, 2021 Very New to all this, what wires do I need to connect for my Aem wideband, and link 3port Boost control solenoid, for the boost control it’s a two wire so one to switched 12v and the other to??? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 22, 2021 Report Share Posted September 22, 2021 For the boost control I would use Aux 7 - pin 11 on the main header. Connect one boost solenoid wire to pin 11 and the other to switched 12V. For the wideband you can connect to any AN Volt input on the expansion loom or pin 13 on the main header which was the original narrowband sensor input. Papajon2.0 1 Quote Link to comment Share on other sites More sharing options...
Papajon2.0 Posted September 24, 2021 Author Report Share Posted September 24, 2021 Now I have a non vanos motor and harness but the ecu is for a vanos harness, I thought they were the same cause the plug is but the pin outs are different.. what is your suggestion for this, have you seen anyone run a non vanos m50 on the G4x? I’m between getting a vanos harness or re-pinning my harness plug Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 24, 2021 Report Share Posted September 24, 2021 The ecu will have no trouble running the non-vanos engine, but as you have found the pinout is very different. The connectors are quite difficult to re-pin on those without damage if you havent done it before. Papajon2.0 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.