Warchild Posted September 29, 2021 Report Share Posted September 29, 2021 HI guys We have an upcoming event next month where we will be advertising the Link range of products. To obviously make the maximum amount of attention, I have been trying to get the car to spit some flames when backing of on the throttle etc. See attached file I have and whether I am on the right track, or what must be changed? What I did was I disabled Overun Fuel cut. Then I made the AFR very lean in the vacuum area when I leave the throttle and the car is in maximum vacuum without my foot on the accelerator. I can hear the pops and bags as they call it, is that it or what else should I do or set. I am also running a water/meth system the whole time, if it is relevant. Again, thank you so much in advance ! 1.2 BAR MAP.pclr Quote Link to comment Share on other sites More sharing options...
essb00 Posted September 29, 2021 Report Share Posted September 29, 2021 On the contrary, on deceleration regions of your fuel/ignition tables should have rich AFR and retarded ignition timing to have pops & bangs. Quote Link to comment Share on other sites More sharing options...
Warchild Posted September 30, 2021 Author Report Share Posted September 30, 2021 Kindly indicate what the timing must be ? 0 or negative numbers or what ? Quote Link to comment Share on other sites More sharing options...
XelloS Posted September 30, 2021 Report Share Posted September 30, 2021 Between 15-20 degrees after TDC will be fine... Quote Link to comment Share on other sites More sharing options...
Warchild Posted September 30, 2021 Author Report Share Posted September 30, 2021 The highligted area is the vacuum area we are talking about, should I change the 30 to 15 and then on the fuel map make it rich ? Quote Link to comment Share on other sites More sharing options...
essb00 Posted September 30, 2021 Report Share Posted September 30, 2021 0 to 20 kPa MAP = ignition timing to -20 to -15 BTDC. KennyJ 1 Quote Link to comment Share on other sites More sharing options...
Warchild Posted October 16, 2021 Author Report Share Posted October 16, 2021 Adam can you perhaps assist me ? I get it kind of going from 3000 rpm and lower when decelerating, but with a lean fuel mixture which is not doing the flames I want... please help, so I can sell some more link ecu's latest-upload-me-16oct.pclr Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.