h82lose91 Posted November 11, 2021 Report Share Posted November 11, 2021 Can someone post up a specific wiring diagram to setup the hold power for this ecu? The main relay wiring seems different from the posted hold power wiring diagrams. Want to have fans and water pump run after key off. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 11, 2021 Report Share Posted November 11, 2021 Dont really think it would be possible, the plug-in is designed to work with the factory main relay control circuit. Quote Link to comment Share on other sites More sharing options...
h82lose91 Posted November 11, 2021 Author Report Share Posted November 11, 2021 Off topic, adding a perfect tuning gauge to CAN1 that currently only has CAN Lambda, any issue there? Does the terminator need to be removed from the gauge? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 11, 2021 Report Share Posted November 11, 2021 Should be fine. If you have a termination resistor at the CAN lambda then remove the gauge one. If no resistor at the CAN lambda then probably best to use the gauge one. Quote Link to comment Share on other sites More sharing options...
h82lose91 Posted November 11, 2021 Author Report Share Posted November 11, 2021 Awesome thank you! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.