beejar Posted November 20, 2021 Report Share Posted November 20, 2021 Are the GP Rev Limit table 1 & 2 only tied to GP input 1 & 2? Can this be changed to another input? The plugin g4x for the evo 9 already has an GP 1 input taken up by the IC Spray manual. Thanks, Rajeeb Quote Link to comment Share on other sites More sharing options...
wastegate Posted November 20, 2021 Report Share Posted November 20, 2021 It's not the same thing. GP Rev Limit is just a general purpose rev limit. You specify what you want the rev limit to act against in the table. For example, you can have Differential Fuel Pressure in the X axis and MAP in the Y. With set rev limits. So if your differential FP goes below or above a certain kPa at a certain MAP kPa then it will limit revs to 3000 for example. Remember that the PCLink help section is VERY informative. There is a whole section on Engine Protection and GP RPM limit. Quote Link to comment Share on other sites More sharing options...
beejar Posted November 20, 2021 Author Report Share Posted November 20, 2021 Thank you for this. I apologize for the redundant question. I don't know why but I was convinced that GP Rev limit tables but tied to GP inputs, I didn't even realize that changing the Y axis could be tied to a GP Input. Again, thank you for this, very much. Rajeeb Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.